SentrySafe QE5541 Handbuch PDF herunterladen (Seite 6)

Icon Identiﬁ cation

(Error) indicates one of the

following:

1. You have pressed Program key out of

sequence.

2. You have entered an invalid code.

3. You have let 5 seconds or more elapse

between key presses.

(Program) Lights after pressing

the Program key and stays lit while

programming a manager or user code.

Lights after three consecutive

invalid codes are input and stays lit

during the 2-minute delay mode.

NOTE: Remember, once you have

decided on your access codes,

open the unit ﬁ rst then test it

with the door open. All zeros is an

invalid code.

There are 3 possible ways to unlock

and access the safe:

1. Factory Code

(Found on the ﬁ rst page of this guide)

You can always open the safe by

entering the pre-set 5-digit factory code.

This code cannot be deleted.

2. Manager Code

If you prefer to employ your own code,

you can program the safe to open to a

4-8 digit manager code of your choice.

Programming the manager code

NOTE: One (1) manager code is

allowed.

To add:

1. Press the Prog/Enter key , then enter

the 5-digit factory code and then

press the Prog/Enter key .

2. An empty lit box icon (

) means

no manager code is programmed.

A boxed lighted * icon (

) means

a manager code is programmed.

3. Enter a 4 to 8 digit code and

press the Prog/Enter key to ﬁ nish

programming the code into the unit.

Programming additional codes

NOTE: Maintain a record of the factory code, user, and manager codes, and

store them in a secure location other than in this safe.

5-E

1 2 3 4 5 6 7 8 9 10 11 ... 32 33

Kommentare zu diesen Handbüchern

Keine Kommentare

SentrySafe QE5541 Handbuch Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Safes SentrySafe QE5541